Skip to content
Home About us Products Resources Blog Contact
Test data

Sodium-Ion vs. LiFePO4 Cold Weather Performance: The Test Data

Cold-weather battery claims are easy to make and hard to verify. This article lays out the measured capacity-retention data for sodium-ion and LiFePO4 across the temperature range, the charging limits that datasheets often bury, and how to read a supplier's low-temperature test report so the numbers are comparable.

How low-temperature performance is measured

Capacity retention at temperature is measured by soaking the cell at the target temperature, then discharging at a standard rate and comparing the delivered capacity against the 25 °C baseline. A claim like "85% at -20 °C" is only meaningful when the discharge rate, soak time and cut-off voltage are stated — a 0.2C result and a 1C result are not comparable numbers.

The data: capacity retention by temperature

Sodium-ion and LiFePO4 diverge sharply once the temperature drops below freezing. The table below compares typical published retention values at a standard discharge rate for cells in our range.

TemperatureSodium-ion (typ.)LiFePO4 (typ.)
25 °C100%100%
0 °C≥ 92%~95%
-10 °C≥ 90%~85%
-20 °C≥ 85%~65–70%
-30 °C≥ 80%severely limited
-40 °C≥ 75%not rated

The charging gap the datasheet may not show

Discharge data is only half the story. LiFePO4 cells cannot be safely charged below 0 °C — doing so causes lithium plating and permanent damage — so an LFP system in a cold climate needs heaters or must idle until warm. Sodium-ion chemistry does not plate the same way, and cells in our range accept charging at -20 °C. For unheated outdoor cabinets and cold-soaked vehicles this is often the deciding number, not discharge retention.

Pulse and cranking data at low temperature

For starter applications the metric is pulse current at temperature, not capacity. Our 26650 high-rate sodium-ion cells are specified for high pulse discharge at low temperature, which is what translates into reliable cold-cranking. See the 26650 cell guide for the exact pulse and continuous ratings.

How to verify a supplier's low-temperature claim

Ask for the full temperature-versus-capacity curve with test conditions: discharge rate, soak duration, cut-off voltage and cell state of charge. Confirm whether the cold rating covers discharge, charging, or both. A reputable supplier supplies this with the datasheet; a vague "works at -40 °C" without conditions is a red flag.

Frequently asked questions

Can sodium-ion batteries be charged in cold weather?

Charging limits are stricter than discharge limits for every chemistry. Sodium-ion tolerates lower charging temperatures than lithium, but you must confirm the supplier's minimum charging temperature.

How much capacity does a sodium-ion battery lose at -20 °C?

Cells in our range typically retain 85% or more of rated capacity at -20 °C at a standard discharge rate, versus roughly 65–70% for LiFePO4.

Discuss your battery requirements

Send the application, required specifications, quantity and destination for a model-specific proposal.

Request a quote